دانلود مقاله Magnetron Sputtered TaN Films with Ta Interlayer on Mild Steel با word دارای 5 صفحه می باشد و دارای تنظیمات در microsoft word می باشد و آماده پرینت یا چاپ است

فایل ورد دانلود مقاله Magnetron Sputtered TaN Films with Ta Interlayer on Mild Steel با word کاملا فرمت بندی و تنظیم شده در استاندارد دانشگاه و مراکز دولتی می باشد.

این پروژه توسط مرکز مرکز پروژه های دانشجویی آماده و تنظیم شده است

توجه : در صورت  مشاهده  بهم ریختگی احتمالی در متون زیر ،دلیل ان کپی کردن این مطالب از داخل فایل ورد می باشد و در فایل اصلی دانلود مقاله Magnetron Sputtered TaN Films with Ta Interlayer on Mild Steel با word،به هیچ وجه بهم ریختگی وجود ندارد

بخشی از متن دانلود مقاله Magnetron Sputtered TaN Films with Ta Interlayer on Mild Steel با word :

سال انتشار: 1391
محل انتشار: اولین همایش ملی تصفیه آب و پساب های صنعتی
تعداد صفحات: 5
نویسنده(ها):
Kourosh motevalli – Department of Applied Chemistry, Islamic Azad University, South Tehran Branch, Tehran, Iran
Zahra yaghoubi – Faculty of Industrial Engineering, Islamic Azad University, South Tehran Branch, Tehran, Iran

چکیده:

The aim of the study is to extend the TaN coating on Mild Steel (MS) with Ta interlayer to explore the benefits of hard nitride coatings on low-cost structural material and to compare the coating with TaN monolithic coating on SS. TaN on MS and SS was deposited by reactive d.c. magnetron sputtering at various N2 /Ar flow ratios and substrate bias. Deposition rate decreased from 22 to 12 nm/min (without biasing) and from 11 to 3 nm/min (02 V biasing) when FN2 /FAr ratio was varied from zero to 227. Deposition rate decreased with the increase in bias voltage. Coatings showed hexagonal Ta2 N, cubic TaN, and hexagonal × TaN as major phases with the increasing N2 flow. Surface hardness reached a maximum of 2202 HK20 at a FN2 /FAr of 227. Critical loads, for cohesive and adhesive failure for coating on MS, were between 1–3 N and 4–12 N respectively; for coating on SS, the values were between 2–10 N and 12–20 N respectively. Duplex coatings were studied for hardness by Knoop microindentation, adhesion by scratch tester, and corrosion by potentiodynamic polarization technique. Hardness, adhesion, and corrosion resistance all improved when TaN coating was incorporated with Ta interlayer on MS.